HP ProCurve 5406zl User Manual

6-14
Stack Management for the 3500, 3500yl, 6200yl and 6600 Switches
Configuring Stack Management
Figure 6-8. The Default Stack Configuration Screen
3. Move the cursor to the Stack State field by pressing
[E] (for Edit).
4. Do one of the following:
• To disable stacking on the Candidate, use the Space bar to select
the Disabled option, then go to step 5.
Note: Using the menu interface to disable stacking on a Candidate
removes the Candidate from all stacking menus.
• To insert the Candidate into a specific Commander’s stack:
i. Use the space bar to select Member.
ii. Press
[Tab] once to display the Commander MAC Address param-
eter, then enter the MAC address of the desired Commander.
• To change Auto Join or Transmission Interval, use
[Tab] to select the
desired parameter, and:
– To change Auto Join, use the Space bar.
– To change Transmission Interval, type in the new value in the
range of 1 to 300 seconds.
Note: All switches in the stack must be set to the same transmis-
sion interval to help ensure proper stacking operation. HP recom-
mends that you leave this parameter set to the default 60 seconds.
Then go to step 5.

HP ProCurve 5406zl Specifications

General

Product Name	HP ProCurve 5406zl
Category	Switch
Layer	Layer 3
Operating Temperature	32°F to 131°F (0°C to 55°C)
Operating Humidity	15% to 95% non-condensing
Management	SNMP, CLI
Power Supply	Redundant power supplies (optional)
Memory	128 MB flash, 512 MB SDRAM