HP ProCurve 5406zl User Manual

6-32
Stack Management for the 3500, 3500yl, 6200yl and 6600 Switches
Configuring Stack Management
Figure 6-26. Example of the Commander’s Show Stack Screen with Only the Commander
Discovered
Using a Member’s CLI to Convert the Member to the Commander of a
New Stack. This procedure requires that you first remove the Member from
its current stack, then create the new stack. If you do not know the MAC
address for the Commander of the current stack, use show stack to list it.
Syntax: no stack
stack commander < stack name >
Suppose, for example, that an HP switch named “Bering Sea” is a Member of
a stack named “Big_Waters”. To use the switch’s CLI to convert it from a stack
Member to the Commander of a new stack named “Lakes”, you would use the
following commands:
Big_Waters-0(config)# show stack
Stacking - Stacking Status (This Switch)
Stack State : Commander
Transmission Interval : 60
Stack Name : Big_Waters Number of members : 14
Auto Grab : No Members unreachable : 0
SN MAC Address System Name Device Type Status
-- ------------- ------------- -------------------- -----------------
0 1cc1de-cfbc80 Big_Waters-0 HP Switch Commander Up
The stack commander command
configures the Commander and names
the stack.
The Commander appears in the stack as Switch
Number (SN) 0.

HP ProCurve 5406zl Specifications

General

Product Name	HP ProCurve 5406zl
Category	Switch
Layer	Layer 3
Operating Temperature	32°F to 131°F (0°C to 55°C)
Operating Humidity	15% to 95% non-condensing
Management	SNMP, CLI
Power Supply	Redundant power supplies (optional)
Memory	128 MB flash, 512 MB SDRAM