HP ProLiant BL280c - G6 Server - Page 87

Troubleshooting 87
NOTE: For the location of server LEDs and information on their statuses, refer to the server
documentation.
Possible causes:
• Improperly seated or faulty internal or external component
• Unsupported component installed
• Redundancy failure
• System overtemperature condition
Item See
1 "Management agents (on page 65)" or in the HP ProLiant Servers
Troubleshooting Guide located on the Documentation CD or on the HP
website (http://www.hp.com/support
)
2
• "Integrated Management Log (on page 69)" or in the HP ProLiant
Servers Troubleshooting Guide located on the Documentation CD or
on the HP website (http://www.hp.com/support
)
• "Event list error messages" in the HP ProLiant Servers Troubleshooting
Guide located on the Documentation CD or on the HP website
(http://www.hp.com/support
)
3 "Component identification (on page 7)"
4 System Management Homepage (https://localhost:2381)
5 "Power-on problems flowchart ("Server blade power-on problems
flowchart" on page 80)"
6
• "Hardware problems" in the HP ProLiant Servers Troubleshooting
Guide located on the Documentation CD or on the HP website
(http://www.hp.com/support
)
• Maintenance and service guides for c-Class server blades, located on
the Documentation CD or the HP website
(http://www.hp.com/go/bladesystem/documentation
)
• "HP contact information (on page 99)"
7
• "Hardware problems" in the HP ProLiant Servers Troubleshooting
Guide located on the Documentation CD or on the HP website
(http://www.hp.com/support
)
• Maintenance and service guides for c-Class server blades, located on
the Documentation CD or the HP website
(http://www.hp.com/go/bladesystem/documentation
)