HP ProLiant BL460c Gen9 - Hardware Options Installation

Removal and replacement procedures 30
4.
Press down firmly on the mezzanine assembly handles, and then close the mezzanine assembly latch.
5. Install the access panel ("Access panel" on page 24).
FlexibleLOM
To remove the component:
1. Power down the server blade (on page 22).
2. Remove the server blade (on page 23).
3. Place the server blade on a flat, level work surface.
4. Remove the access panel ("Access panel" on page 24).
5. Remove the mezzanine assembly ("Mezzanine assembly" on page 27).
6. Use the FlexibleLOM handle to remove the FlexibleLOM from the system board.
To replace the component, reverse the removal procedure.