HP ProLiant DL120 - PCI-X Riser Board Option

Hardware options installation 36
PCI-X riser board option
To install the component:
1. Power down the server (on page 15).
2. Remove the server from the rack (on page 15).
3. Remove the access panel (on page 16).
4. Disconnect all internal cables connected to existing expansion boards.
5. Remove the PCI riser board assembly (on page 16).
6. Remove all installed expansion boards.
7. Remove the PCIe riser board from the assembly.
8. Install the optional PCI-X riser board.
9. Install a PCI-X expansion board ("Expansion board option" on page 34).
IMPORTANT: The server does not power up if the PCI riser board assembly is not seated
properly.
10. Install the PCI riser board assembly (on page 17).