Removal and replacement procedures 62
To remove the hard drive:
1. Press the hard disk carrier button to release the ejector lever.
2. Use the HDD carrier latch to pull the drive out of the cage.
Make sure to support the drive when pulling it out of the cage.
3. Pull the hard drive assembly out of the drive bay.
Figure 18 Removing the Hard Drive
To install the hard drive:
1. Pull the hard drive blank out of the chassis.
Figure 19 Removing the Hard Drive Blank
IMPORTANT: Do not discard the hard drive blank. If the drive is removed in the future, you must
reinstall the hard drive blank to maintain proper system airflow.
To Next Page
Loading...
