Removal and replacement procedures 76
To install the new processor:
4. Inserting the processor into the processor installation tool.
Figure 38 Inserting the Processor into the Tool
5. Align the processor installation tool to the socket and then install the processor.
Figure 39 Inserting the Processor
6. Press down firmly until the processor installation tool clicks and separates from the processor,
and then remove the processor installation tool.
7. Close the retention plate.
8. Lock the load lever.
CAUTION: To prevent overheating or a possible system crash, use only a heat sink model specified
for the HP ProLiant DL180 G6 server.
To Next Page
Loading...
