Removal and replacement procedures 80
To remove the memory module:
1. Completely open the holding clips securing the memory module.
2. Gently pull the memory module upward to remove it from the slot.
Figure 44 Removing the Memory Module
CAUTION: Place the memory module on a static-dissipating work surface or inside of an anti-static
bag.
To install the memory module:
1. Align the notch on the bottom edge of the memory module with the keyed surface of the DIMM
slot and then fully press the memory module into the slot until the holding clips snap back in
place.
Figure 45 Installing the Memory Module
CAUTION: The DIMM slots are structured to ensure proper installation. If you insert a DIMM but it
does not fit easily into the slot, you may have inserted it incorrectly. Reverse the orientation of the
DIMM and insert it again.
To Next Page
Loading...
