HP ProLiant DL360 - Page 100

Diagnostics and Troubleshooting
Compaq ProLiant DL360 Server Maintenance and Service Guide 4-37
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
6000 – 6099, Compaq NIC Boards Test Error Codes
The 6000 series of diagnostic error codes identifies failures with some Compaq Network Interface
Controllers.
Table 4-11: Compaq Network Interface Boards Test Error Codes
Error Code Description Recommended Action
6000-xx Network card ID failed.
6001-xx Network card setup failed.
6002-xx Network card transmit failed.
6014-xx Network card configuration
failed.
6016-xx Network card reset failed.
6028-xx Network card internal failed.
6029-xx Network card external failed.
6089-xx Network card open failed.
6090-xx Network card initialization
failed.
6091-xx Network card internal loopback
failed.
6092-xx Network card external
loopback failed.
Check the controller
installation in the PCI slot.
6500 – 6599, SCSI Hard Drive Test Error Codes
The 6500 series of diagnostic error codes identifies failures with SCSI hard drives, SCSI hard
drive controller boards, SCSI hard drive cabling, and system board functions. If the system
uses a drive array controller, see the section for Array Diagnostic Utility (ADU).
Table 4-12: SCSI Hard Drive Test Error Codes
Error Code Description Recommended Action
6500-xx SCSI disk ID drive types test
failed.
6502-xx SCSI disk unconditional format
test failed.
6505-xx SCSI disk read test failed.
6506-xx SCSI disk SA/media test
failed.
6509-xx SCSI disk erase tape test
failed.
6523-xx SCSI disk random read test
failed.
6528-xx Media load/unload test failed.
1. Run the System
Configuration Utility and
verify the drive type.
2. Replace the SCSI disk
drive signal and power
cables and retest.
3. Replace the SCSI
controller and retest.
4. Replace the SCSI disk
drive and retest.
5. Replace the system board
and retest.