HP ProLiant DL360 - Page 101

Diagnostics and Troubleshooting
4-38 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
6600 – 6699, SCSI/IDE CD-ROM Drive Test Error Codes
The 6600 series of diagnostic error codes identifies failures with the CD-ROM drive cabling,
CD-ROM drives, adapter boards, or the system board assembly.
Table 4-13: SCSI/IDE CD-ROM Drive Test Error Codes
6600-xx
6605-xx
6608-xx
CD-ROM ID failed.
CD-ROM read failed.
SCSI controller test.
6605-xx CD-ROM read failed.
1. Replace the CD-ROM
media and retest.
2. Check and/or replace the
signal cable and retest.
3. Check the switch settings
on the adapter board (if
applicable).
4. Replace the SCSI
controller (if applicable)
and retest.
5. Replace the CD-ROM
drive and retest.
6. Replace the system board
and retest.
6700 – 6799, SCSI Tape Drive Test Error Codes
The 6700 series of diagnostic error codes identifies failures with tape cartridges, tape drives,
media changers, tape drive cabling, adapter boards, or the system board assembly.
Table 4-14: SCSI Tape Drive Test Error Codes
Error Code Description Recommended Action
6700-xx SCSI tape ID drive types test
failed.
6706-xx SCSI disk SA/media test
failed.
6709-xx SCSI disk erase tape test
failed.
6728-xx Media load/unload test failed.
1. Run the System
Configuration Utility and
verify the drive type.
2. Replace the SCSI tape
drive signal and power
cables and retest.
3. Replace the SCSI
controller and retest.
4. Replace the SCSI tape
drive and retest.
5. Replace the system board
and retest.