HP ProLiant DL360 - Page 105

Diagnostics and Troubleshooting
4-42 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
Table 4-16: ADU Diagnostic Messages continued
Message Description Recommended Action
Accelerator
status:
Warranty alert
Catastrophic problem with array
accelerator board. Refer to other
messages on Diagnostics screen
for exact meaning of this message.
Replace the array accelerator board.
Adapter/NVR
AM ID
mismatch
Nonvolatile RAM has an ID for a
different controller from the one
physically present in the slot.
Run the System Configuration Utility.
Array
accelerator
battery pack X
not fully
charged
Battery is not fully charged. If 75% of batteries present are fully
charged, array accelerator is fully
operational. If less than 75% of batteries
are fully charged, allow 36 hours to
recharge them.
Array
accelerator
battery pack X
below
reference
voltage
(recharging)
Battery pack on array accelerator is
below required voltage levels.
Allow enough time for batteries to
recharge (36 hours). If batteries have not
recharged after 36 hours, replace the
array accelerator board.
Board in use
by expand
operation
Array accelerator memory is in use
by Expand operation.
Operate system without array accelerator
board until Expand operation completes.
Board not
attached
Array controller configured for use
with array accelerator board, but
one is not attached.
Attach array accelerator board to array
controller.
Configuration
signature is
zero
ADU detected that nonvolatile RAM
contains a configuration signature
of zero. Old versions of the System
Configuration Utility could cause
this.
Run the latest version of System
Configuration Utility to configure the
controller and nonvolatile RAM.
Configuration
signature
mismatch
Array accelerator board configured
for a different array controller
board. Configuration signature on
array accelerator board does not
match the one stored on the array
controller board.
To recognize the array accelerator board,
run the Array Configuration Utility.
Controller
communicatio
n failure
occurred
Controller communication failure
occurred.
ADU was unable to successfully issue
commands to the controller in this slot.
Controller
detected.
NVRAM
configuration
not present
Nonvolatile RAM does not contain a
configuration for this controller.
Run the System Configuration Utility to
configure the nonvolatile RAM.
Controller
firmware
needs
upgrading
Controller firmware is below the
latest recommended version.
Run Options ROMPaq to upgrade the
controller to the latest firmware revision.
continued