Removal and Replacement Procedures
2-12 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MicroMachine Part Number: 169616-006 Last Saved On: 12/31/01 11:05 AM
DVD-ROM/Diskette Drive Assembly
To eject the DVD-ROM/diskette drive assembly:
1. Power down the server. See “Powering Down the Server” earlier in this chapter.
2. Locate your shipping/ejector key. See “Shipping/Ejector Key” earlier in this chapter.
3. Insert the shipping/ejector key approximately 0.5 in (1.25 cm) into the
DVD-ROM/diskette ejector port on the lower right corner of the server front panel to
eject the drives.
2
1
Figure 2-7: Ejecting the DVD-ROM/diskette drive assembly
CAUTION: Do not operate the server without either the DVD-ROM/diskette drive assembly o
the bezel blank, because thermal damage can occur.
To Next Page
Loading...
