Removal and Replacement Procedures
2-20 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MicroMachine Part Number: 169616-006 Last Saved On: 12/31/01 11:05 AM
PCI Riser Board Assembly
To remove the PCI riser board assembly:
1. Complete the preparation procedures. See “Powering Down the Server” earlier in this
chapter.
2. Remove the access panel. See “Server Access Panel” earlier in this chapter.
3. Disconnect any cables leading from any current expansion boards to the system board.
4. Lift the expansion board retaining lever.
Figure 2-157: Lifting the expansion board retaining lever (expansion
boards removed for clarity)
To Next Page
Loading...
