Removal and Replacement Procedures
2-22 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MicroMachine Part Number: 169616-006 Last Saved On: 12/31/01 11:05 AM
Expansion Board (32-Bit Slot)
To remove an expansion board from the 32-bit slot:
1. Complete the preparation procedures. See “Powering Down the Server” earlier in this
chapter.
2. Remove the access panel. See “Server Access Panel” earlier in this chapter.
3. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” earlier in this
chapter.
4. Slide the expansion board out of the 32-bit slot.
Figure 2-17: Removing an expansion board from the 32-bit
expansion slot
CAUTION: Always ensure that an expansion board or expansion slot cover is
installed before powering up and operating the server. Failure to install either an
expansion board or expansion slot cover can lead to improper cooling and
resulting thermal damage.
Reverse steps 1 through 4 to replace an expansion board in the 32-bit expansion slot, ensuring
that the expansion board slides into the guiding groove, aligning with the slot.
To Next Page
Loading...
