Removal and Replacement Procedures
2-32 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MicroMachine Part Number: 169616-006 Last Saved On: 12/31/01 11:05 AM
CD-ROM (DVD-ROM)/Diskette Drive Assembly Backplane
To remove the CD-ROM (DVD-ROM)/diskette drive assembly backplane:
1. Remove the CD-ROM (DVD-ROM)/diskette drive assembly. See “CD-ROM/diskette
Drive Assembly” or “DVD-ROM/diskette drive assembly” earlier in this chapter.
2. Complete the preparation procedures. See “Powering Down the Server” earlier in this
chapter.
3. Remove the access panel. See “Server Access Panel” earlier in this chapter.
4. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” earlier in this
chapter.
5. Remove the air baffle. See “Air Baffle” earlier in this chapter.
6. Remove the AC power cord and filter. See “AC Power Cord and Filter” earlier in this
chapter.
7. Remove the power supply. See “Power Supply” earlier in this chapter.
8. Remove the optional internal array controller interface assembly. See “Internal Smart
Array/SCSI Controller Interface Assembly” earlier in this chapter.
9. Remove the cable protector. See “Cable Protector” earlier in this chapter.
10. Disconnect the 100-pin connector from the system board
.
1
Figure 2-28: Disconnecting the 100-pin CD-ROM (DVD-ROM)/diskette
drive assembly cable from the system board
To Next Page
Loading...
