Removal and Replacement Procedures
2-34 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MicroMachine Part Number: 169616-006 Last Saved On: 12/31/01 11:05 AM
User Interface Board
To remove the user interface board:
1. Remove the CD-ROM (DVD-ROM)/diskette drive assembly. See “CD-ROM/diskette
Drive Assembly” or “DVD-ROM/diskette Drive Assembly” earlier in this chapter.
2. Complete the preparation procedures. See “Powering Down the Server” earlier in this
chapter.
3. Remove the access panel. See “Server Access Panel” earlier in this chapter.
4. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” earlier in this
chapter.
5. Remove the air baffle. See “Air Baffle” earlier in this chapter.
6. Remove the AC power cord and filter. See “AC Power Cord and Filter” earlier in this
chapter.
7. Remove the power supply. See “Power Supply” earlier in this chapter.
8. If installed, remove the optional internal array controller interface assembly. See
“Internal Smart Array/SCSI Controller Interface Assembly” earlier in this chapter.
9. Remove the cable protector. See “Cable Protector” earlier in this chapter.
10. Remove the CD-ROM (DVD-ROM)/diskette drive assembly backplane. See “CD-ROM
(DVD-ROM)/diskette Drive Assembly Backplane” earlier in this chapter.
11. Slide the user interface board toward the rear of the server and lift to remove the board
.
1
Figure 2-31: Removing the user interface board
Reverse steps 1 through 11 to replace the user interface board.
To Next Page
Loading...
