Removal and Replacement Procedures
Compaq ProLiant DL360 Server Maintenance and Service Guide 2-35
COMPAQ CONFIDENTIAL Codename: MicroMachine Part Number: 169616-006 Last Saved On: 12/31/01 11:05 AM
Memory
Observe the following guidelines when installing additional memory:
• The server ships standard with a single 128-MB Synchronous DRAM (SDRAM) Dual
Inline Memory Module (DIMM) installed in DIMM socket 1.
• SDRAM DIMMs must be 133-MHz, registered, 3.3-volt, 72-bit wide, with Error
Correction Code (ECC). No other DIMMS are compatible with the server.
• Install DIMMs of the same speed. Do not install DIMM modules supporting different
speeds.
• Use only 64-, 128-, 256-, 512-MB, or 1-GB SDRAM DIMMs. Any combination of these
SDRAM DIMMs can be used.
• Install DIMMs only in one direction. Be sure to match the notch on the module with the
tab on the DIMM slot. Before seating the DIMM in the slot, ensure that the module key is
fully inserted.
• Memory can be expanded to a maximum of 4-GB of memory.
• Use only Compaq SDRAM DIMMs. DIMMs from other sources may affect data
integrity.
• Install SDRAM DIMM modules one at a time in the sequential order starting with DIMM
socket 1.
To Next Page
Loading...
