HP ProLiant DL360 - System Board

Removal and Replacement Procedures
Compaq ProLiant DL360 Server Maintenance and Service Guide 2-45
COMPAQ CONFIDENTIAL Codename: MicroMachine Part Number: 169616-006 Last Saved On: 12/31/01 11:05 AM
System Board
To remove the system board:
1. Complete the preparation procedures. See “Powering Down the Server” earlier in this
chapter.
2. Remove the access panel. See “Server Access Panel” earlier in this chapter.
3. Remove the hot-plug SCSI hard drive(s). See “Hot-Plug SCSI Hard Drives” earlier in this
chapter.
4. Remove the SCSI backplane. See “SCSI Backplane” earlier in this chapter.
5. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” earlier in this
chapter.
6. Remove the air baffle. See “Air Baffle” earlier in this chapter.
7. Remove the fan assembly. See “Fan Assembly” earlier in this chapter.
8. Remove the AC power cord and filter. See “AC Power Cord and Filter” earlier in this
chapter.
9. Remove the power supply. See “Power Supply” earlier in this chapter.
10. If installed, remove the optional internal array controller interface assembly.
11. Disconnect the 100-pin connector from the system board.
12. Remove any SDRAM DIMMs. See “SDRAM DIMMs” earlier in this chapter.
13. Remove the processor(s). See “Processors” earlier in this chapter.
14. Remove the Integrated Smart Array Controller. See “Integrated Smart Array Controller”
earlier in this chapter.
15. Identify the alignment keys and keyhole locations
 through  on the system board.
1
2
3
4
5
6
11
10
9
8
7
Figure 2-39: Identifying alignment keys and keyhole locations