HP ProLiant DL360 - Page 83

Diagnostics and Troubleshooting
4-20 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
Table 4-2: POST Error Messages continued
Error Code Audible Beeps
Probable Source of
Problem Recommended Action
1776-Slot x Drive
Array- SCSI Bus
Termination
Error-internal and
external drive
cannot both be
attached to the
same SCSI port.
SCSI port (y).
Check cables.
None External and internal SCSI
drives are both configured
Port 1.
The internal and external
connectors of the specified
SCSI port(s) are both attached
to drives. The SCSI bus is not
properly terminated when
internal and external drives are
attached concurrently to the
SCSI bus. The indicated SCSI
bus is disabled until this
problem is resolved. Turn off
the server power and check the
cabling to the specified SCSI
port. Press the F1 key to
resume.
1777-Slot x Drive
Array ProLiant
DL360 server
drive storage
enclosure
problem detected
(followed by one
or more of the
following )
SCSI Port (y)
Cooling fan
malfunction
detected
SCSI port (y)
Overheated
condition
detected
SCSI port (y)
Side panel must
be closed to
prevent
overheating
SCSI port (y)
Redundant power
supply
malfunction
detected.
SCSI port (y)
Wide SCSI
transfer failed
SCSI port (y)
Interrupt signal
inoperative
None Cooling fan failure, internal
temperature alert or open
side panel
Check cooling fan operation by
placing hand over fan. Check
internal plenum cooling fan in
tower servers or storage
systems. If fan is not operating,
check for obstructions and
check all internal connectors.
Replace unit side panel if
removed.
If the ProLiant DL360 Storage
System power LED is amber
instead of green this indicates
a redundant power supply
failure.
Check SCSI cables. If the
message indicates that the
SCSI cables should be
checked, please verify the
cabling with the diagrams in
the Integrated Smart Array
Controller User Guide. If the
routing is correct, replace the
cables on the specified port
until the POST message is
eliminated.
Press the F1 key to resume.
continued