Diagnostics and Troubleshooting
4-26 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
Table 4-2: POST Error Messages continued
Error Code Audible Beeps
Probable Source of
Problem Recommended Action
1793-Drive Array
- Array
Accelerator
Battery Depleted
- Data Lost
(Error message
1794 also
displays.)
None This indicates that while the
system was in use, power
was interrupted while data
was in the array accelerator
memory. Array accelerator
batteries failed. Power was
not restored within 8 to 10
days. Data in array
accelerator has been lost.
Perform orderly system
shutdowns to avoid data
remaining in the array
accelerator.
1794-Drive Array
- Array
Accelerator
Battery Charge
Low. Array
Accelerator is
temporarily
disabled. Array
Accelerator will
be re-enabled
when battery
reaches full
charge.
None This is a warning that the
battery charge is below
75%. Posted-writes are
disabled.
Replace the array
accelerator board if
batteries do not recharge
within 36 power-on hours.
1795-Drive Array
- Array
Accelerator
Configuration
Error.
Data does not
correspond to this
drive array. Array
Accelerator is
temporarily
disabled.
None This indicates that while the
system was in use, power
was interrupted while data
was in the array accelerator
memory.
The data stored in the array
accelerator does not
correspond to this drive
array.
Match the array accelerator to
the correct drive array, or run
the System Configuration Utility
to clear the data in the array
accelerator.
1796-Drive Array
- Array
Accelerator Not
Responding.
Array Accelerator
is temporarily
disabled.
None Array accelerator is
defective or has been
removed.
1. Check that the array
accelerator is properly
seated.
2. Run the System
Configuration Utility to
reconfigure the Compaq
IDA-2 without the array
accelerator.
continued
To Next Page
Loading...
