Diagnostics and Troubleshooting
Compaq ProLiant DL360 Server Maintenance and Service Guide 4-25
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
Table 4-2: POST Error Messages continued
Error Code Audible Beeps
Probable Source of
Problem Recommended Action
* The 1788 error message might display inadvertently due to a bad power cable connection to the drive
or by noise on the data cable. If this message was due to a bad power cable connection, but not
because of an incorrect drive replacement, repair the connection and press the F2 key.
-Or-
If this message was not due to a bad power cable connection, and no drive replacement took place, this
could indicate noise on the data cable. Check cable for proper routing.
-Or-
If this message is due to a defective SCSI cable, replace the cable.
1789-Slot x Drive
array SCSI
physical drive(s)
Not Responding.
Check the cables
or replace the
following drives:
SCSI port (x),
SCSI ID (x).
Select F1 to
continue - drive
array will remain
disabled.
Select F2 to fail
drive(s) that are
not responding
-Interim Recovery
Mode will be
enabled if
configured for
fault tolerance.
None Cable or hard drive failure 1. Check the cable
connections.
2. Replace the cables.
3. Replace the drive. If you
do not want to replace the
drive now, press the F2
key.
1790-Disk 0
Configuration
Error
None Hard drive error or wrong
drive type
Run the System Configuration
Utility and Diagnostics and
correct.
1791-Disk 1 Error None Hard drive error or wrong
drive type
Run the System Configuration
Utility and Diagnostics and
correct.
1792-Drive Array
Reports Valid
Data Found in
Array
Accelerator.
Data will
automatically be
written to drive
array.
None This indicates that while the
system was in use, power
was interrupted while data
was in the array accelerator
memory. Power was then
restored within 8 to
10 days, and the data in the
array accelerator was
flushed to the drive array.
No action necessary; no data
has been lost. Perform orderly
system shutdowns to avoid
data remaining in the array
accelerator.
continued
To Next Page
Loading...
