Removal and replacement procedures 46
c.
Finish the installation by completely tightening the screws in the same sequence.
4. Install the access panel.
5. Do one of the following:
o Slide the server into the rack.
o Install the server into the rack.
6. Connect each power cord to the server.
7. Connect each power cord to the power source.
8. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
Processor
The server supports single-processor and dual-processor operations.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor
configurations must contain processors with the same part number.
CAUTION: To prevent possible server overheating, always populate processor socket 2 with a
processor and a heatsink or a processor socket cover and a heatsink blank.
IMPORTANT: If installing a processor with a faster speed, update the system ROM before
installing the processor.
To Next Page
Loading...
