About this task
Follow the steps below to replace the DL360p G8 SRVR Dual Port PCIe 1GB NIC or DL360p G8
SRVR 1GbE 4-port 331FLR Adapter FIO kit.
Note:
Always follow safe electrostatic discharge practices.
Procedure
1. Power down the server according to Avaya's application instructions.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove any attached network cables.
4. Extend the server from the rack
5. Remove the access panel
6. Loosen the thumbscrew.
7. Remove the existing FlexibleLOM
a. Loosen the thumbscrew (1 on the following image).
b. Remove the Flexible LOM (2 on the following image).
Internal server components
September 2013 Maintaining and Troubleshooting the HP ProLiant DL360p G8 Server 25
Comments on this document? infodev@avaya.com
To Next Page
Loading...
