To Next Page

To Previous Page

Installation overview

This section outlines the procedures to follow when using RIS to install Windows CCS 2003 obtained

through a Microsoft Volume Licensing program on ProLiant servers. The RIS installation procedures

referenced in this document complement the standard RIS installation procedures for Windows CCS

2003. The standard RIS installation instructions are available in the "Installing Remote Installation

Service" section of the Installing Compute Cluster instructions on the Microsoft TechCenter website

(

http://go.microsoft.com/fwlink/?LinkID=64198).

To complete a Windows CCS 2003 installation using RIS that is fully supported by HP, complete all of

the phases and steps listed below. Before beginning the installation, read the instructions for all

phases completely.

A Windows CCS 2003 installation using RIS consists of the following installation phases:

• Install server hardware, racks, and cabling

• Install Windows Server 2003, Compute Cluster Edition on the head node

• Install and configure Microsoft Compute Cluster Pack on the head node

• Configure RIS on the head node

• Install Windows CCS 2003 on the compute nodes using RIS

• Update other drivers manually

NOTE:

The instructions provided in this Integration Note are for

Windows CCS 2003 using Windows Service Pack 1 and

Compute Cluster Pack version 1. It does not include instructions

for Windows Service Pack 2 or Windows Deployment

Services.

Pre-installation tasks

To prepare for installation, ensure that the following conditions are met:

1. Ensure that the network topology (switches and cabling) supports RIS and Windows CCS 2003

(see the Windows Compute Cluster Server 2003 Getting Started Guide on the Compute Cluster

Pack CD).

2. Install all supported server hardware (including memory, CPUs, disks, and controllers) properly.

3. Connect all power connections and verify functionality.

Installation procedure

Install Windows Server 2003, Compute Cluster Edition on the head

node

Complete the following steps to install Windows Server 2003, Compute Cluster Edition on the head

node, the server that provides management and job scheduling services to the compute cluster. For

detailed instructions on standard installations of Windows Server 2003, Compute Cluster Edition, see

the “Installing Compute Cluster Edition” section under Compute Cluster Server: Deployment at

http://technet2.microsoft.com/WindowsServer/en/Library.

HP ProLiant DL360p Installation

Other manuals for HP ProLiant DL360p