HP ProLiant DL360p User Manual

Option ROM Configuration for Arrays 11
During POST, all controllers in the server are initialized one at a time in the current boot order sequence.
If a controller is connected to one or more hard drives, a message appears during the initialization
process for that controller, prompting you to start ORCA.
2. At the ORCA prompt for the controller that you want to configure, press the F8 key.
The ORCA main menu appears, enabling you to do the following:
o Create, view, or delete a logical drive ("Creating a logical drive with ORCA" on page 11)
o Enter an SAAP license key ("Installing a license key with ORCA" on page 12)
Creating a logical drive with ORCA
1. Power up the server.
POST runs.
During POST, all controllers in the server are initialized one at a time in the current boot order sequence.
If a controller is connected to one or more hard drives, a message appears during the initialization
process for that controller, prompting you to start ORCA.
2. At the ORCA prompt for the controller that you want to configure, press the F8 key.

HP ProLiant DL360p Specifications

General

Max Processors	2
Form Factor	1U Rack
Memory	Up to 768GB DDR3
Memory Slots	24
RAID Support	HP Smart Array P420i Controller
Network	4 x 1Gb Ethernet ports
Power Supply	460W, 750W
Management	HP iLO (Integrated Lights-Out)
Storage	8 SFF or 4 LFF