HP ProLiant DL360p

HP Array Configuration Utility 42
For more information, see "Using the ACU GUI (on page 30)."
2. Select a controller from the Controller/Device menu.
The Configuration screen appears.
3. Configure the controller:
o To configure manually, see "Performing a Configuration task (on page 42)."
o To configure with a wizard, see "Using Wizards (on page 48)" or "Using Express Configuration (on
page 50)."
4. When prompted, save the configuration.
5. Do one of the following:
o Configure an additional controller. Repeat steps 3 through 5.
o Click Exit ACU.
Performing a Configuration task
1. Open ACU.
For more information, see "Using the ACU GUI (on page 30)."
If ACU is already open, click the Configuration tab.
2. Select a device from the Controller/Device menu.