HP Array Configuration Utility 47
• Physical drive error logs
ACU Diagnostics never collects information about the data content of logical drives. The diagnostic report
does not collect or include the following:
• File system types, contents, or status
• Partition types, sizes, or layout
• Software RAID information
• Operating system device names or mount points
Performing a Diagnostics task
1. Open ACU.
For more information, see "Using the ACU GUI (on page 30)."
If ACU is already open, click the Diagnostics/SmartSSD tab.
The Diagnostics/SmartSSD screen appears with the following selections:
o View SmartSSD Wear Gauge Report
o Generate SmartSSD Wear Gauge Report
o Run Array Diagnostic Reports
For this example, use the diagnostic reports selection.
2. Select Run Array Diagnostic Reports.
The array diagnostic report screen appears.
3. Select a device or devices from the Report Contents panel.
The Available Tasks panel appears. For more information, see "Diagnostics tasks (on page 46)."
To Next Page
Loading...
