Removal and replacement procedures 37
5.
Disconnect all cables from the hard drive backplane.
6. Remove the hard drive backplane.
To replace the component, reverse the removal procedure.
SFF hard drive cage
To remove the component:
1. Power down the server (on page 24).
2. Extend or remove the server from the rack ("Remove the server from the rack" on page 25, "Extend the
server from the rack" on page 25).
3. Remove the access panel ("Access panel" on page 29).
4. Remove all hot-plug hard drives ("Hot-plug SAS hard drive" on page 29).
5. Disconnect all cables from the hard drive backplane.
To Next Page
Loading...
