HP ProLiant DL380 G6 - Page 38

Removal and replacement procedures 38
6.
Remove the hard drive backplane ("SFF hard drive backplane" on page 36).
7. Remove the hard drive cage.
To replace the component, reverse the removal procedure.
LFF hard drive backplane
To remove the component:
1. Power down the server (on page 24).
2. Extend or remove the server from the rack ("Remove the server from the rack" on page 25, "Extend the
server from the rack" on page 25).
3. Remove the access panel ("Access panel" on page 29).
4. Remove all hot-plug hard drives ("Hot-plug SAS hard drive" on page 29).
5. Disconnect all cables from the hard drive backplane.