60 HP ProLiant DL380 Generation 3 Server Maintenance and Service Guide
Do not attempt to recharge the battery. •
•
•
•
Do not expose the battery to temperatures higher than
60°C (140°F).
Do not disassemble, crush, puncture, short external contacts,
or dispose of in fire or water.
Replace only with the spare designated for this product.
To remove the component:
1. Power down the server.
2. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 16
, "Removing the Server from the Rack" on page 18).
3. Remove the access panel ("Removing the Access Panel" on page 19
).
4. Remove the PCI riser cage ("PCI Riser Cage" on page 44
).
CAUTION: To prevent damage to the server or expansion
boards, power down the server and remove all AC power cords before
removing or installing the PCI riser cage.
5. Remove the battery.
IMPORTANT: Replacing the system board battery resets the system
ROM to its default configuration. After replacing the battery, reconfigure
the system through RBSU.
HP CONFIDENTIAL
File Name: 291916-6.doc Last Saved On: 2/5/04 2:26 PM
To Next Page
Loading...
