HP ProLiant DL380e Gen8 Manual&Nbsp;

HP Server ROM HP ROM (Read Only Memory) is now digitally signed using HP's Corporate Signing Service. This signature is
verified before the flash process starts, reducing accidental programming and preventing malicious efforts
to corrupt system ROM.
HP ROM provides for essential initialization and validation of hardware components before control is
passed to the customer-installed operating system. The ROM also provides the capability of booting from
various fixed media (HDD, CD-ROM) and removable media (USB), to continue operation to the operating
system.
HP ROM performs very early configuration of the video controller, to allow monitoring of initialization
progress via an attached monitor. If configuration or hardware errors are discovered during this early
phase of hardware initialization, suitable messages are now displayed on the connected monitor.
Additionally, these configuration or hardware errors are logged to the Integrated Management Log (IML) to
assist in diagnosis.
HP's ProLiant ROM is used to configure the following:
Processor and chipset status registers
System memory, memory map, and memory initialization
System hardware configuration (Integrated PCI devices and optional PCIe cards).
Customer-specific BIOS configuration (using the HP ROM-Based Setup Utility (RBSU).
NOTE: For further information, please refer to HP's RBSU (ROM based setup utility) user guide:
www.hp.com/support/rbsu .
Storage Controller
One of the following
depending on Model
Entry Model - SATA HP Dynamic Smart Array B120i Controller
NOTE: Provides support for up to 6 SATA drives and data transmission speeds
up to 3Gb/s
Entry Model - SAS HP Dynamic Smart Array B320i/512MB FBWC Controller
NOTE: Provides support for up to 8 SAS/SATA drives, data transmission
speeds up to 6Gb/s and includes SAS license key.
Base Models - LFF HP Dynamic Smart Array B320i/512MB FBWC Controller
NOTE: Provides support for up to 8 SATA drives, data transmission speeds up
to 6Gb/s and requires purchase of SAS license key for SAS mode.
Base Model - SFF HP Dynamic Smart Array B320i/512MB FBWC Controller
NOTE: Provides support for up to 8 SAS/SATA drives, data transmission
speeds up to 6Gb/s and includes SAS license key.
High Performance Models HP Smart Array P420/1GB FBWC Controller (RAID 0/1/1+0/5/5+0/6/6+0)
Storage Models - LFF HP Smart Array P420/1GB FBWC Controller (RAID 0/1/1+0/5/5+0/6/6+0)
Storage Models - SFF HP Smart Array P420/2GB FBWC Controller (RAID 0/1/1+0/5/5+0/6/6+0)
QuickSpecs
HP ProLiant DL380e Generation 8 (Gen8)
Standard Features
DA - 14328 Worldwide — Version 27 — December 16, 2013 Page 5

HP ProLiant DL380e Gen8 Specifications

General

Bus type	QPI
Stepping	M1
FSB Parity	No
Scalability	2S
Processor code	SR0LS
Processor cache	10 MB
Processor cores	4
Processor model	E5-2403
System bus rate	6.4 GT/s
Processor series	Intel Xeon E5-2400
Processor socket	LGA 1356 (Socket B2)
Processor codename	Sandy Bridge EN
Motherboard chipset	Intel C600
Processor frequency	1.8 GHz
Processor cache type	Smart Cache
Processor lithography	32 nm
Processor manufacturer	Intel
Processor package size	45 x 42.5 mm
Processor front side bus	- MHz
Processor operating modes	64-bit
ECC supported by processor	Yes
Supported instruction sets	AVX
Thermal Design Power (TDP)	80 W
Number of processors installed	1
Maximum number of PCI Express lanes	24
Memory types supported by processor	DDR3-SDRAM
Memory channels supported by processor	Triple
Memory clock speeds supported by processor	800, 1066 MHz
Memory bandwidth supported by processor (max)	25 GB/s
Maximum internal memory supported by processor	375 GB
Memory slots	12
Internal memory	4 GB
Memory clock speed	1333 MHz
Maximum internal memory	384 GB
Memory layout (slots x size)	1 x 4 GB
HDD size	- \
RAID levels	0, 1, 0+1, 5, 5+0
HDD interface	Serial ATA, Serial Attached SCSI (SAS)
Total storage capacity	0 GB
Maximum storage capacity	- TB
Number of HDDs installed	0
Number of HDDs supported	8
Cabling technology	10/100/1000Base-T(X)
USB 2.0 ports quantity	6
PCI Express slots version	3.0
Power supply	460 W
Redundant power supply (RPS) support	-
Chassis type	Rack (2U)
Processor ARK ID	64615
Intel Identity Protection Technology version	0.00

Weight and Dimensions

Depth	698.5 mm
Width	445.5 mm
Height	87.4 mm
Weight	42990 g