HP ProLiant DL380e - Page 44

Removal and replacement procedures 44
3.
Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 32).
4. Remove the access panel ("Access panel" on page 35).
5. Remove the air baffle ("Air baffle" on page 38).
6. Disconnect all cables connected to the fan board.
7. Remove all fan blanks and modules ("Hot-plug fan blank and module" on page 40).
8. Remove the fan cage.
9. Remove the fan board ("Fan board" on page 44).
To replace the component, reverse the removal procedure.
Fan board
To remove the component:
1. Power down the server (on page 29).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 32).
4. Remove the access panel ("Access panel" on page 35).
5. Remove the air baffle.
6. Remove the fan cage ("Fan cage" on page 43).