Removal and replacement procedures 45
7.
Remove the fan board.
To replace the component, reverse the removal procedure.
DIMMs
General DIMM slot population guidelines
Observe the following guidelines for all AMP modes:
• Install DIMMs only if the corresponding processor is installed.
• Do not mix LRDIMMs, UDIMMs, or RDIMMs.
• White DIMM slots denote the first slot of a channel (1-A, 2-B, 3-C).
• When two processors are installed, install the DIMMs in sequential alphabetical order balanced
between the two processors: P1-A, P2-A, P1-B, P2-B, P1-C, P2-C, and so forth.
• The minimum DIMM requirement to make this server bootable is one DIMM installed in slot 1-A.
For detailed memory configuration rules and guidelines, use the Online DDR3 Memory Configuration Tool
on the HP website (http://www.hp.com/go/ddr3memory-configurator).
Removing a DIMM
1. Power down the server (on page 29).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
To Next Page
Loading...
