HP ProLiant DL380e - Set Admin Password (G7 Servers); Trusted Platform Module (G7 Servers)

Removal and replacement procedures 60
o
Low-profile riser board
To replace the component, reverse the removal procedure.
PSU air baffle
To remove the component:
1. Power down the server (on page 29).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 32).
4. Remove the access panel ("Access panel" on page 35).
5. If necessary, remove rear drive cables that are secured in the PSU air baffle latches.
6. Remove the PSU air baffle.