Removal and replacement procedures 61
To replace the component, reverse the removal procedure.
Rear drive cage
To remove the component:
1. Power down the server (on page 29).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 32).
4. Remove the access panel ("Access panel" on page 35).
5. Remove the rear drives ("Hot-plug drive" on page 33).
6. Disconnect all cables connected to the drive cage backplane.
7. Remove the rear drive cage:
o 2 LFF rear drive cage
To Next Page
Loading...
