HP ProLiant DL380e - Page 63

Removal and replacement procedures 63
To remove the component:
1. Power down the server (on page 29).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 32).
4. Remove the access panel ("Access panel" on page 35).
5. If the cache module is installed on the system board, remove the PCI riser cage ("PCI riser cage" on
page 53).
CAUTION: When connecting or disconnecting the capacitor pack cable, the connectors on the
cache module and cable are susceptible to damage. Avoid excessive force and use caution to
avoid damage to these connectors.
6. Disconnect the capacitor pack cable from the cache module.
7. Remove the cache module:
o Cache module on the system board