HP ProLiant DL380p Generation8

NOTE: Power Specification and Technical Content for supported power supplies can be
found at:
http://h18000.www1.hp.com/products/quickspecs/14209_na/14209_na.html
Step 3: Choose Additional Factory Integratable Options (only one of the following from each
list unless otherwise noted)
HP Rack Kits NOTE: Gen8 rail kits have changed significantly from prior generation rail kits. Please
take a moment to review the installation documentation that comes with the server to
help you with the installation of your Gen8 server.
NOTE: Rail kits are optional for DL380p Gen8 and are no longer included standard with
the server. Customers have the option to purchase their server without a rail kit. The HP
2U Gen8 Cable Management Arm is not available when using Friction Rails.
NOTE: To assist in the installation of the server into the rack, an optional installation
tool is available by contacting your local services representative (p/n 695539-001).
Caution: HP recommends that a minimum of two people are required for all Rack Server
installations. Please refer to your installation instructions for proper tools and number
of people to use for any installation.
NOTE: See HP Rack Options in Additional Options section of this QuickSpecs for more
rack kit choices.
HP 2U Friction Gen8 Rail FIO Kit
NOTE: Kit contains non-telescoping friction rails which do not allow for in-rack
serviceability. The HP Gen8 Cable Management Arm is not available when using Friction
Rails.
663476-B21
Step 4: Choose Additional Options for Factory Integration
NOTE: For additional options, please refer to the "Core Options and Additional Options" section below.
QuickSpecs
HP ProLiant DL380p Generation8 (Gen8)
Configuration Information - Factory Integrated Models
DA - 14212 North America — Version 38 — July 22, 2013 Page 31