8.
Remove the three T-10 Torx screws, and then detach the front bezel.
To replace the component, reverse the removal procedure.
Power supply backplane
To remove the component:
1. Power down the server (on page 26).
2. Remove all power supplies ("Hot-plug power supply" on page 28).
3. Extend or remove the server from the rack ("Extend the server from the rack" on page 25, "Remove
the server from the rack
" on page 27).
4. Remove the access panel ("Access panel" on page 30).
5. Remove the power supply backplane.
To replace the component, reverse the removal procedure.
Removal and replacement procedures 35
To Next Page
Loading...
