2.
Remove the three T-10 Torx screws, and then detach the front bezel.
To replace the component, reverse the removal procedure.
Front left bezel
To remove the component:
1. Power down the server (on page 26).
2. Extend or remove the server from the rack ("Extend the server from the rack" on page 25, "Remove
the server from the rack
" on page 27).
3. Remove the access panel ("Access panel" on page 30).
4. Remove the PCI riser cage ("PCI riser cage" on page 38).
5. Remove the air baffle ("Air baffle" on page 39).
6. Extend or remove the Systems Insight Display ("Systems Insight Display" on page 33).
7. Disconnect the System Insight Display cable from the system board.
Removal and replacement procedures 34
To Next Page
Loading...
