Item Description
10 System maintenance switch
11 Power supply backplane connector
12 Processor 1 socket
13 Primary riser connector
14 Secondary riser connector
15 Diagnostic LEDs
16 Processor 2 socket
17 Processor 2 DIMM slots
18 Fan 6 connector
19 Fan 5 connector
20 Fan 4 connector
21 Fan 3 connector
22 Fan 2 connector
23 Fan 1 connector
System board switches
aintenanc
tion ult
System m e switch
Posi Defa Function
S1 Off Off = iLO 2 security is enabled.
On = iLO 2 security is disabled.
S2 Off nged.
m configuration is locked.
Off = System configuration can be cha
On = Syste
S3 Off Reserved
S4 Off Reserved
S5 Off
sword disabled.
Off = Power-on password enabled.
On = Power-on pas
S6 Off Off = No function
On = ROM reads system configuration as invalid.
When the system maintenance switch position 6 is set to the On position, the system is prepared to erase
all system configuration settings from both CMOS and NVRAM.
RBSU setting that erases default settings and fixed disk partitions, which causes a loss of data.
CAUTION: Clearing CMOS and/or NVRAM deletes configuration information. There is an
Diagnostic LEDs
tion ition Posi Pos Function
S7 S8 Diagnostic LEDs
Off Off Port 85
Off On Port 84
Component identification 75
To Next Page
Loading...
