Removal and replacement procedures 29
10.
Using the T-15 Torx screwdriver, remove the three screws on each side of the front bezel.
NOTE: The T-15 Torx screwdriver is shipped with the server and can be located on the rear panel ("Rear
panel components" on page 77).
11. While holding down the rack locking levers, slide the bezel to the right, and detach the bezel from
the server.
To replace the component, reverse the removal procedure.
Removing the system cage
Installing or accessing some options in the server might require removing the system cage. See the
instructions for each individual option to determine if removing the system cage is necessary.
To remove the system cage:
1. Power down the server (on page 27).
2. Extend the server from the rack, if applicable ("Extending the server from the rack" on page 26).
3. Remove the access panel ("Removing the access panel" on page 28).
To Next Page
Loading...
