Removal and replacement procedures 30
4.
Remove all hot-plug power supplies ("Removing a redundant hot-plug power supply" on page 52).
5. Remove all system fans ("Replacing hot-plug fans" on page 53).
6. Remove all expansion boards ("Removing a non-hot-plug expansion board" on page 38, "Removing
a PCI-X Hot Plug expansion board" on page 40).
7. Remove the expansion slot cover ("Removing the expansion slot cover" on page 38).
8. Remove the PCI-X Hot Plug basket ("Removing the PCI-X Hot Plug basket" on page 39), if installed.
9. Remove the PCI-X Hot Plug mezzanine ("Removing the PCI-X Hot Plug mezzanine option" on page
40) or the PCI Express mezzanine ("Removing the PCI Express mezzanine option" on page 41), if
applicable.
10. Loosen the thumbscrews, and lift the system cage from the server.
NOTE: The T-15 Torx screwdriver can be used to loosen the thumbscrews. The T-15 Torx screwdriver is
shipped with the server and can be located on the rear panel ("Rear panel components" on page 77).
Removing a diskette, DVD, CD-RW drive or blank
1. Power down the server (on page 27).
2. Use the T-15 Torx screwdriver to eject the drive, and pull the drive out of the server.
To Next Page
Loading...
