Removal and replacement procedures 59
10. Install the capacitor pack.
11. Route the cable.
12. Install the access panel.
13. For ML110 G6 servers, slide the server back into the rack.
14. For ML150 G6 servers, do one of the following:
• Close or install the tower bezel, as needed.
• Slide the server back into the rack.
15.
Power up the server.
Flash-backed write cache capacitor pack
To remove the component:
1. Back up all data.
2. Close all applications.
3. Power down the server.
CAUTION: In systems that use external data storage, be sure that the server is the first unit to
be powered down and the last to be powered back up. Taking this precaution ensures that
the system does not erroneously mark the drives as failed when the server is powered up.
4. Extend the server from the rack.
5. Remove the access panel.
To Next Page
Loading...
