Removal and replacement procedures 66
2. Release the power cord from the strain relief clip.
3. Remove the strain relief clip from RPS and retain the clip for future use.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Place the server on a sturdy, level surface.
6. Remove the access panel (on page 25).
7. If installed, remove the PCI air baffle (on page 27).
8. Remove the system air baffle (on page 28).
9. Disconnect all power supply cables from the system board, drive cages, and devices.
To Next Page
Loading...
