25
7. Install the memory module:
a. Orient the module so that the notch on the bottom edge of the module aligns with the keyed surface of
the DIMM socket, and then press it fully into the socket.
The memory sockets are structured to ensure proper installation. If you insert a memory module but it
does not fit easily into the socket, you may have inserted it incorrectly. Double-check the orientation of
the module and reinsert.
b. Firmly press the latches inward to secure the memory module in place.
If the latches do not close, the module is not inserted correctly.
Figure -27 [Installing a memory module]
8. Observe the post-installation procedures.
Expansion cards
You must remove the PCI expansion slot cover lock before installing or removing expansion cards.
The server supports the following:
• Two 32-bit/33-MHz 3.3V PCI slots (J20 to J21)
• One PCI-Express x4 link with x4 slot (J33)
• One PCI Express x8 link with x16 slot (J32)
Figure -28 [PCI slot location]
To install an expansion card:
1. Perform steps 1 through 3 of the Pre-installation instructions.
2. Remove the access panel.
3. If necessary, remove any accessory boards or cables that prevent access to the PCI slots.
4. Remove the PCI slot cover lock from the rear of the server to gain access to the expansion slots:
a. Remove the retaining screw that secures the lock to the chassis.
b. Remove the slot cover lock from the chassis.
To Next Page
Loading...
