Installing Microsoft Windows Server 2003 and Windows Small Business Server 2003
Phase 3 - Adding Terminal Server Services
1. Click Start | Settings | Control Panel | Add Remove Programs.
2. Click Add/Remove Windows Components.
3. Locate then select the [Terminal Services] checkbox then click Next.
4. Select the mode you want to use then click Next.
There are two mode options: Remote administration mode and Application server
mode.
NOTE: The following instructions are based on the Application server mode. Please note the licensing
requirement listed on the screen for this mode. Consult with your Microsoft representative for setting the
licensing server.
5. Select the default permissions for application compatibility then click Next.
6. Click Next to accept the support tools and administrator tools settings.
7. If prompted, insert the Windows 2003 CD-ROM.
8. Click Finish to close the wizard.
9. Click Yes to restart the system.
Be sure to remove the Windows 2003 CD-ROM from the drive.
10. After the system reboots, log on to the system.
11. Click Start | Settings | Control Panel | Administrative Tools.
12. Check that the following services are now available:
•
•
•
Terminal Services Client Creator
Terminal Services Configuration
Terminal Services Manager
To create Client Installation diskettes:
1. Double-click Terminal Services Client Creator.
2. Select the appropriate client type for your environment.
3. Click Format disk if needed.
4. Check the number of disks required and label them as Terminal Services for […] Disk
[x/y].
5. Click OK to proceed.
6. Follow the on-screen instructions to create the diskettes copies.
7. Click OK at the [y] floppies were created…
screen.
8. Click Cancel to close the Create Installation Disks utility.
2-6 HP ProLiant ML110 Server Network Operating System Installation Guide
To Next Page
Loading...
Need help?
General
