Removal and replacement procedures 26
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the server.
1. Shut down the OS as directed by the OS documentation.
2. Press the Power On/Standby button to place the server in standby mode. When the server enters
standby power mode, the system power LED changes to amber.
3. Disconnect the power cords.
The system is now without power.
Remove the server from the rack
If the server is installed with an optional rack enabling kit, remove the server from the rack before beginning
any service procedures.
1. Power down the server (on page 25).
2. Disconnect peripheral devices and power cables.
3. Loosen the thumbscrews and slide the locking bracket backward.
4. Extend the server and tray from the rack.
5. Disconnect the straps securing the server to the tray.
To Next Page
Loading...
