Removal and replacement procedures 29
Access panel
To remove the component:
1. Power down the server (on page 25).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Bezel" on page 27).
o Extend the server from the rack ("Remove the server from the rack" on page 26).
3. Loosen the access panel screws.
4. Slide the access panel back about 1.5 cm (0.5 in).
5. Lift and remove the access panel.
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, hard drives, or blanks installed.
To replace the component, reverse the removal procedure.
Media bay blank
To remove the component:
1. Power down the server (on page 25).
2. Open or remove the tower bezel, as needed ("Bezel" on page 27).
CAUTION: Always populate each media bay with either a device or a blank. Proper airflow can
only be maintained when the bays are populated. Unpopulated drive bays can lead to improper
cooling and thermal damage.
3. Remove the media bay blank.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
