Removal and replacement procedures 31
3.
Remove the hard drive.
To replace the component:
1. Slide the drive into the cage until it clicks, locking the drive into place.
2. Close the lever.
IMPORTANT: When the drive is inserted, the drive LEDs flash for 2 seconds to indicate that the
drive is seated properly and receiving power.
3. As the drive begins to spin, be sure that the drive LEDs illuminate one at a time and then turn off together
to indicate that the system has recognized the new drive.
4. In fault-tolerant configurations, allow the replacement drive to be reconstructed automatically with data
from the other drives. While reconstruction is in progress, the online LED flashes.
Power button/LED cable
To remove the component:
1. Power down the server (on page 25).
2. Remove the bezel ("Bezel" on page 27).
3. Remove the access panel ("Access panel" on page 29).
4. Remove the media drive in the bottom bay, if necessary ("Full-height media device" on page 34,
"Half-height media device" on page 32).
5. Disconnect the power button/LED cable from the system board ("System board components" on page
77).
To Next Page
Loading...
