HP ProLiant ML330 Generation 3

Removal and Replacement Procedures
6. Disengage the power button:
a. From the front of the chassis, squeeze the sides of the power button to disengage the
two retainer clips from the chassis.
b. Gently remove the power button from the chassis.
7. Disengage the LEDs:
a. Squeeze the sides of the LED to disengage the two retainer clips from the chassis.
b. Gently remove the LED from the chassis.
c. Repeat for the other LEDs.
To replace the component, reverse the removal procedure.
HP ProLiant ML330 Generation 3 Server Maintenance and Service Guide 2-31